Buuuut how do we squeeze all the engagement out of the consumer? And keep them on reoccurring billing around the engagement? And cram in adds and last make a passable game that it all stems from. But we’re not going to try too hard on that last one.

This^. Also I like to tweak the models like for me that’s part of the hobby, tweak the machine. Also Ive seen a lot of that instant shit is ai slop

There’s always save scumming I’m sure

Honestly it looks like the nozzle could be too hot cause I don’t see any consisten lines

I start at 62(and stay there) that’s the magic number i found for my sovol 6 and 6 plus, at lower I would experience warping and bad bed adhesion. And I’ve had the same correlation with mine at home and the 3 I have at work

I usually have to run mine between 62-65, kinda depends how cold my house is but that’s the same bed I have on my sovols, also get a playing card and make sure you can barely feel the nozzle on the surface of the card. That’s how I do mine

What’s the bed temp at? I usually have to run mine around 62C for PLA and turn the cooling fan to 20% or off.

This is what I was planning, I added a small nvme drive to my desktop to put Linux on

Is dual boot a good way to ease yourself in? I literally just made a new nvme partition to try a dual boot

Any particularly recommended? I started dabbling in Linux recently and trying to find one I really like.